BIANCO-8MWN150
8" Midwoofer
Free. Just your email.
Frequency response and impedance
Level in dB (left axis) and impedance in ohm (right axis), 10 Hz to 20 kHz. The line on each switch above shows how its curve is drawn.
Features
- Proprietary cone paper material made in-house
- Neodymium magnet
- 2.4" voice coil with APC (Advanced Polymer Coating)
- Minimum damping fiber glass voice coil former
- CCAW voice coil wire for reduced moving mass
- Vented pole piece for reduced compression
- Long life silver lead wires
Features as listed by SB Audience. Full details on sbaudience.com (opens the SB Audience website in a new tab)
Specifications
- Nominal impedance
- 8 Ω
- Minimum impedance
- 6.8 Ω
- DC resistance, Re
- 6.8 Ω
- Voice coil inductance, Le
- 1.07 mH
- Free air resonance, Fs
- 74 Hz
- Total Q, Qts
- 0.38
- Electrical Q, Qes
- 0.4
- Mechanical Q, Qms
- 8.97
- Equivalent volume, Vas
- 9.9 L
- Effective piston area, Sd
- 227 cm²
- Xmax
- 5.98 mm
- Moving mass, Mms
- 34 g
- Force factor, Bl
- 16.5 Tm
- Compliance, Cms
- 0.14 mm/N
- Mechanical loss, Rms
- 1.76 kg/s
- Sensitivity (1 W / 1 m)
- 93 dB
- AES power handling
- 150 W
- Maximum power handling
- 300 W
Read from the SB Audience datasheet. Check the current datasheet before you rely on a figure.
Design files
BIANCO-8MWN150 FRD and ZMA files, in one zip:
- Frequency responses at 0, 30 and 60 degrees (.frd)
- Impedance (.zma)
- A README and a note on how each curve was made
Plain text files for VituixCAD, XSim, REW and most other crossover tools.
Free. Just your email.
BIANCO-8MWN150 FAQ
What are FRD and ZMA files?
An FRD file holds a driver's frequency response and a ZMA file its impedance, the two curves a crossover simulator needs. Plain text, one point per line.
Which software can open the BIANCO-8MWN150 files?
VituixCAD, XSim and REW, and most other crossover tools that read plain text.
How was this data made?
It was digitised by Artisan Acoustics from the response and impedance graphs in the SB Audience datasheet, so it is not a measurement and not an official SB Audience file. Each curve is checked against its graph. The datasheet it came from and the conditions printed on it are in the ABOUT.txt note and in the header of each file inside the zip. Use the files at your own risk.
Why is the phase column zero?
The datasheets print level and impedance but not phase. If your simulator needs phase, derive minimum phase there.
Where can I buy the BIANCO-8MWN150 in Singapore or Malaysia?
From Artisan Acoustics, the official SB Audience distributor for Singapore and East and West Malaysia. Message us on WhatsApp