NERO-6MRN150D
6" Midrange
Free. Just your email.
Frequency response and impedance
Level in dB (left axis) and impedance in ohm (right axis), 10 Hz to 20 kHz. The line on each switch above shows how its curve is drawn.
Features
- Proprietary cone paper material with graphite
- Flat foam surround for best midrange reproduction
- High grade neodymium magnet
- Shorting ring in motor system for reduced distortion
- CCAW voice coil for reduced moving mass
- Minimum damping fiber glass voice coil former
- Cast aluminium chassis
Features as listed by SB Audience. Full details on sbaudience.com (opens the SB Audience website in a new tab)
Specifications
- Nominal impedance
- 8 Ω
- Minimum impedance
- 5.6 Ω
- DC resistance, Re
- 5.6 Ω
- Voice coil inductance, Le
- 0.28 mH
- Free air resonance, Fs
- 200 Hz
- Total Q, Qts
- 0.48
- Electrical Q, Qes
- 0.58
- Mechanical Q, Qms
- 2.96
- Equivalent volume, Vas
- 1.1 L
- Effective piston area, Sd
- 136.8 cm²
- Xmax
- 3.43 mm
- Moving mass, Mms
- 13.8 g
- Force factor, Bl
- 13.1 Tm
- Compliance, Cms
- 0.04 mm/N
- Mechanical loss, Rms
- 6 kg/s
- Sensitivity (1 W / 1 m)
- 98 dB
- AES power handling
- 150 W
- Maximum power handling
- 300 W
Read from the SB Audience datasheet. Check the current datasheet before you rely on a figure.
Design files
NERO-6MRN150D FRD and ZMA files, in one zip:
- Frequency responses at 0, 30 and 60 degrees (.frd)
- Impedance (.zma)
- A README and a note on how each curve was made
Plain text files for VituixCAD, XSim, REW and most other crossover tools.
Free. Just your email.
NERO-6MRN150D FAQ
What are FRD and ZMA files?
An FRD file holds a driver's frequency response and a ZMA file its impedance, the two curves a crossover simulator needs. Plain text, one point per line.
Which software can open the NERO-6MRN150D files?
VituixCAD, XSim and REW, and most other crossover tools that read plain text.
How was this data made?
It was digitised by Artisan Acoustics from the response and impedance graphs in the SB Audience datasheet, so it is not a measurement and not an official SB Audience file. Each curve is checked against its graph. The datasheet it came from and the conditions printed on it are in the ABOUT.txt note and in the header of each file inside the zip. Use the files at your own risk.
Why is the phase column zero?
The datasheets print level and impedance but not phase. If your simulator needs phase, derive minimum phase there.
Where can I buy the NERO-6MRN150D in Singapore or Malaysia?
From Artisan Acoustics, the official SB Audience distributor for Singapore and East and West Malaysia. Message us on WhatsApp