SB29SDNC-C000-4
Fabric Dome Tweeter
Free. Just your email.
Frequency response and impedance
Level in dB (left axis) and impedance in ohm (right axis), 10 Hz to 20 kHz. The line on each switch above shows how its curve is drawn.
Features
- Large surround dome for increased acoustic output
- CCAW voice coil for low moving mass
- Long life silver lead wires
- Low resonance frequency
- Copper cap on pole piece for reduced voice coil inductance and minimum phase shift
- Inherently shielded neodymium motor system
- Internal pressure equalization and flow resistor for non-resonant coupling of cavities
- Compact design
Features as listed by SB Acoustics. Full details on sbacoustics.com (opens the SB Acoustics website in a new tab)
Specifications
- Nominal impedance
- 4 Ω
- DC resistance, Re
- 3 Ω
- Voice coil inductance, Le
- 0.05 mH
- Free air resonance, Fs
- 630 Hz
- Total Q, Qts
- 0.49
- Electrical Q, Qes
- 0.79
- Mechanical Q, Qms
- 1.3
- Effective piston area, Sd
- 9.6 cm²
- Linear coil travel (p-p)
- 0.5 mm
- Moving mass, Mms
- 0.45 g
- Force factor, Bl
- 2.6 Tm
- Sensitivity (2.83 V / 1 m)
- 95.5 dB
- Rated power handling
- 80 W
Read from the SB Acoustics datasheet. Check the current datasheet before you rely on a figure.
Design files
SB29SDNC-C000-4 FRD and ZMA files, in one zip:
- Frequency responses at 0, 30 and 60 degrees (.frd)
- Impedance (.zma)
- A README and a note on how each curve was made
Plain text files for VituixCAD, XSim, REW and most other crossover tools.
Free. Just your email.
SB29SDNC-C000-4 FAQ
What are FRD and ZMA files?
An FRD file holds a driver's frequency response and a ZMA file its impedance, the two curves a crossover simulator needs. Plain text, one point per line.
Which software can open the SB29SDNC-C000-4 files?
VituixCAD, XSim and REW, and most other crossover tools that read plain text.
How was this data made?
It was digitised by Artisan Acoustics from the response and impedance graphs in the SB Acoustics datasheet, so it is not a measurement and not an official SB Acoustics file. Each curve is checked against its graph. The datasheet it came from and the conditions printed on it are in the ABOUT.txt note and in the header of each file inside the zip. Use the files at your own risk.
Why is the phase column zero?
The datasheets print level and impedance but not phase. If your simulator needs phase, derive minimum phase there.
Where can I buy the SB29SDNC-C000-4 in Singapore or Malaysia?
From Artisan Acoustics, the official SB Acoustics distributor for Singapore and East and West Malaysia. Message us on WhatsApp